Insights · Networking & Connectivity

Signs Your Business Wi-Fi Needs Upgrading

Key takeaways

  • Plug a laptop in by cable first. If wired is also slow, the problem is the internet service, not the Wi-Fi.
  • Dropouts on calls, slowdowns at busy times and dead spots are the classic signs of consumer gear stretched too far.
  • Wi-Fi extenders and chained routers are stopgaps. Cabled access points are the fix.
  • Separate staff, guest and device networks to limit the damage from any one compromised device.
  • Wi-Fi 6 or 6E is plenty for most offices. Fix placement and cabling before paying for Wi-Fi 7.

Your business Wi-Fi needs upgrading if video calls break up, everything slows when the whole team is in, some rooms have weak signal, or one consumer router and a couple of extenders run the entire office. Before you spend money, work out whether the Wi-Fi or the internet service is the problem. The fixes are different.

Is it your Wi-Fi or your NBN connection?

Plug a laptop into the router with an Ethernet cable and run a speed test. Then run the same test over Wi-Fi in the problem area.

  • Wired is slow too: the problem is the internet service, the router, congestion or a fault. Contact your internet provider. NBN Co sells to providers, not to end users, so faults go through your provider. The nbn website explains typical speeds.
  • Wired is fast, Wi-Fi is slow or unstable: the wireless network is the weak link, and the signs below will show why.

What are the signs your business Wi-Fi needs upgrading?

Calls and meetings drop or stutter

Teams, Zoom and VoIP are sensitive to jitter and packet loss. If voices cut out while a file download runs fine, the wireless link is struggling.

It slows down when everyone is in

If speed is fine at 7am and poor at 10am on Monday, the access point is overloaded. Consumer routers often handle a handful of devices well, then fall over as phones, laptops, tablets and printers pile on.

Some rooms have weak or no signal

A single router in a comms cupboard or behind the front desk will not push through plasterboard, brick, concrete and metal racking. In a warehouse conversion or an older shopfront, one box rarely covers the lot.

Devices will not roam properly

Laptops cling to a distant access point instead of moving to a closer one, so people walking between rooms get dropped. Business systems support roaming standards (802.11k, v and r) and coordinate channels centrally.

Extenders or chained routers are holding it together

Extenders repeat the signal wirelessly and typically halve the throughput at each hop. Two routers daisy-chained cause double NAT and odd problems with VoIP and VPNs. Both are stopgaps.

The equipment is old or no longer gets updates

Gear that is five to seven years old is usually Wi-Fi 4 or Wi-Fi 5, often without WPA3, and sometimes has not had a firmware update in years. Unpatched network equipment is a security risk as well as a performance one.

Staff, guests and devices share one network

If visitors, payment terminals, cameras, printers and staff laptops all sit on the same Wi-Fi, one compromised device can reach the rest. Card terminals in particular should not share a network with guests.

Nobody can see what is connected

If you cannot say how many devices are on the network or which one is hogging bandwidth, you are guessing. Business systems with a central controller show you.

The business has changed

More staff, VoIP, cloud apps, cameras and video calls all increase the load. In dense areas, neighbouring networks also crowd the 2.4GHz band, so a setup that worked three years ago may not work now.

What does a proper business Wi-Fi setup look like?

Option Suits Limits
Consumer router or mesh kit A very small office with a handful of devices Little management, weak separation between networks, and wireless links between nodes cut speed.
ISP router plus extenders A temporary fix Slow, unstable roaming, and hard to troubleshoot.
Cabled business access points, for example Ubiquiti UniFi, with a managed switch and gateway Offices, shops and warehouses with several staff or a large floor area Needs cabling and a design. Higher upfront cost, far fewer problems.

In a good setup, ceiling-mounted access points are cabled back to a managed switch with Power over Ethernet. A proper gateway or firewall handles routing, and a central controller manages everything from one screen.

Cabling quality matters as much as the access points. Cat6 runs to each access point, labelled at both ends and tested, give you a network that can be upgraded later without rewiring the ceiling.

The network is split into separate networks for staff, guests and devices such as printers and cameras. Channels and transmit power are planned so access points do not talk over each other. WPA3 is used where your devices support it.

Our network and Wi-Fi solutions start by walking the site, marking where people work and where signal fails, then placing, cabling and tuning each access point.

Is Wi-Fi 7 worth it for an office?

Wi-Fi 6 and 6E are more than enough for most offices. Wi-Fi 7 helps when your laptops and phones also support it, and many do not yet. If you are replacing equipment anyway, buying Wi-Fi 7 access points is reasonable. But a well-placed, cabled Wi-Fi 6 network beats a poorly placed Wi-Fi 7 one.

When the problem is the internet, not the Wi-Fi

A home-grade NBN plan in a business with ten staff often fails at the same point: upload speed. Cloud backups, video calls and file sync all send data upstream, and many plans have a low upload limit. Business NBN offers higher upload speeds, a static IP address, and Premium plans with matched download and upload speeds and 4-hour fault restoration.

If an internet outage would stop sales or phones, add a 4G or 5G failover. It keeps VoIP and card terminals running when the NBN drops. See 4G and 5G failover and data SIMs. For help choosing a plan, read business NBN vs home NBN.

A simple checklist before you spend money

  1. Run a wired speed test and a Wi-Fi speed test in the worst spot.
  2. Note the make, model and age of the router and any access points, and check whether firmware updates are still published.
  3. Mark on a floor plan where signal drops and where calls fail.
  4. Count the devices, including phones, printers, cameras and terminals.
  5. Check whether guests and staff share a network.
  6. Ask for a design with access point positions and cable runs before you buy hardware.

If you would rather have someone look at it, our managed IT plans include monitoring, so network problems show up before staff complain.

FAQ

Questions people ask

How do I know if the problem is my Wi-Fi or my NBN?

Connect a laptop by Ethernet cable and run a speed test, then repeat over Wi-Fi in the problem area. If both are slow, look at the internet service, router or a fault. If wired is fast and Wi-Fi is poor, the wireless network is the weak link.

How many people can one access point handle?

It depends on what they are doing, but as a rough guide, a business-grade access point copes with a few dozen active devices. Video calls and large file transfers use far more capacity than email. Placement and channel planning matter as much as the number of access points.

How often should business Wi-Fi equipment be replaced?

Roughly every five to seven years, or sooner if the manufacturer has stopped releasing firmware updates. Older Wi-Fi 4 and Wi-Fi 5 gear also struggles with today's mix of laptops, phones, cameras and cloud apps.

Do I need a separate guest Wi-Fi network?

Yes. Guests should not be able to reach staff computers, printers, servers or payment terminals. A guest network with client isolation is a standard feature of business access points and takes minutes to set up.

Is Wi-Fi 7 worth buying for an office?

Not always. Wi-Fi 6 or 6E handles most offices well, and your devices need Wi-Fi 7 support to benefit from it. If you are replacing equipment anyway, Wi-Fi 7 access points are a reasonable investment, but cabling and placement come first.

Keep reading

More on networking & connectivity

Tell us what's going on. We'll tell you what it costs.

Free consultations for businesses. Fixed-price quotes before any work starts.

Private design preview